Dacor EOR - Manual (Page 14)

12
Installation Instructions
Installing the Oven in the Cabinet
WARNING
Failure to properly install the mounting screws may •
result in movement or tipping of the oven during use
resulting in personal injury.
Do not block the oven air exhaust located at the bot- •
tom of the oven. Blocking the intake may result in a
fire hazard, cabinet damage or poor performance.
The wall oven is heavy. Do not attempt to install it in •
the cabinet with less than two people.
Lift the wall oven up to the cabinet cut out, using the 1.
upper edge of the cavity opening and the bottom of the
oven case side as gripping points. Be certain to take all
necessary safety precautions due to the weight of the
appliance.
Resting the oven on the cabinet-mounting platform, slide 2.
the oven into the recessed area until the rear edge of
the oven frame is flush with the cabinet face and the
oven is centered within the cut out. Ensure that the
electrical conduit slides through the opening in the
cabinet platform or coils above the oven chassis as the
oven is slid into place. The cable must be placed into
the recessed area located along the rear vertical edge
of the oven or coiled above the oven chassis. Do not
trap the appliance cable between the oven case back
and the rear wall.
Locate the mounting holes in the trim on both sides of 3.
the oven. There are four (4) holes, two (2) on each
side, for single oven models and six (6) holes for dou-
ble oven models.
Use a 1/16” drill bit to drill pilot holes in the cabinet 4.
through all of the trim mounting holes.
Install all of the provided #6 screws through the oven 5.
trim into the cabinet to secure the oven. Do not over-
tighten the screws.
Mounting Screws:
Four (4) for single oven
Six (6) for double oven
Gripping
point
Gripping point:
case bottom
both sides