Lenco Boost-6 - Manual (Page 4)

4
Item Description
1 AUX IN (3.5mm Jack, Stereo)
2 Power Switch ON – OFF
3 CTL Button (for Power Bank)
4 Type A USB Socket (DC OUT: DC 5V 1A/1000mA)
5 Micro USB socket (DC Input: DC 5V 2A/2000mA)
6 Foot Stand
7 MIC Position (for hand-free)
8 Button (for Bluetooth Searching)
9 / Button (Play/Pause, Pick up/Hang up call/Last dialed, AUX)
10 Button (Volume down, Previous track)
11 Button (Volume up, Next track)
12 NFC Sensor Position (for Bluetooth pair)
13 Mode LED (3 in 1; Charge- Red , Bluetooth- Blue , AUX IN- Green )
14 Left Bass Radiator
15 Right Bass Radiator
16 Left Speaker
17 Right Speaker
18 Rubber Seal Cover (for splash-proof)
C. About the rechargeable Battery
This Bluetooth Speaker has an internal, non–user-replaceable battery.
For best results, the first time you use this Bluetooth Speaker, let it charge
for about 6 ~ 8 hours or until the charging LED indicator light from On to
off which show you the battery is fully charged.
For maintain the battery life and performance, if speaker isn’t used for
a while, the battery might need to be recharged. Charge the battery at
least once every month.
To charge the rechargeable battery:
1. Connect the Bluetooth Speaker’s “Micro USB socket (5)” with the
USB power charger which able to provides output at least DC 5V 2A
for charge connection via the original USB cable (supplied).
2. The “Charge (13)” LED will turn On in red, the battery is in charging.
3. The “Charge (13)” LED will turn Off when the rechargeable battery is
fully charged.
4. Disconnect the USB cable when it is done.
Use a USB/AC adaptor with following specs 5 volt , 2 ampere . When
using lower ampere like 0,5A. or 0,8 A. , the charging time will be 3 or 4
times longer.
Important:
The device design with high power of audio output and power bank