Lenco Boost-8 - Manual (Page 5)

EN-4
MUTE THE UNIT
During playback, press MUTE button to switch off the audio. Press the button again to resume the
audio.
TREBLE/BASS EFFECT ADJUSTING
During playback, press the TONE button on the unit repeatedly to select BASS or TREBLE, and adjust
the effect of bass or treble via pressing VOLUME +/- button continuously. The effect of the treble and
bass can also be adjusted by pressing TREBLE+/- button or BASS+/- button directly.
VOLUME LEVEL
During playback, press VOLUME+/- button to adjust the volume level accordingly.
TIME DISPLAY

Connect the unit to power supply, the unit will enter standby mode. When the unit is connected to AC
main power, clock time will show on the LCD all the time until you press STANDBY button to turn on
the unit. When the unit is under DC power supply (Battery operated), clock time will show on the LCD
for a while and then disappear, you can press any button (except STANDBY button) to check the
clock time.
 When the unit is switched on by pressing the STANDBY button, if you want to check the clock time,
press the DISPLAY button on the remote control.
 In CD mode and when the playing disc is in CD format (not for MP3 disc), press DISPLAY button will
cycle through the following time display: the elapsed time of current track, the remaining time of
current track, the remaining time of the whole disc, the elapsed time of the whole disc.
SLEEP FUNCTION
Press SLEEP button at power on mode. Each time SLEEP button is pressed, the sleep time changes
on the display. When your desired sleep time shows on the screen, release the SLEEP button. When
the sleep time is expired, the unit will switch off automatically.
CLOCK SETTING
1. In standby mode, press CLOCK button and use SLEEP/HR/MIN button on the unit or press HR
button on the remote to switch between the time modes (12 hours and 24 hours) accordingly. Then
press CLOCK button to confirm your selection.
2. The hour flashes on the display. Press SLEEP/HR/MIN button on the unit repeatedly to set the hour
and press CLOCK button to confirm.
3. The minute flashes on the display. Set the minute by pressing SLEEP/HR/MIN button on the unit
repeatedly, confirm your setting by pressing CLOCK Button.
NOTE: When the hour or minute flashes on the display, the clock can also be set by pressing HR
button or MIN button on the remote directly. After setting, press CLOCK button to confirm.
TIMER SETTING
1. In standby mode, press TIMER button on the unit or on the remote.
To AUX IN jack
To PHONES jack on MP3 player /
AUDIO OUT jack on audio device