Lenco Boost-8 - Manual (Page 6)

EN-5
2. "T" shows on the LCD display with hour flashing. Adjust the hour by pressing SLEEP/HR/MIN button
on the unit continuously and press TIMER Button to confirm.
3. The minute flashes on the display. Set the minute by pressing SLEEP/HR/MIN button on the unit
continuously. Confirm your setting by pressing TIMER button. The timer “ON” shows on the display
to indicate the timer is activated (Press TIMER button again to disable the timer).
Note: When the hour or minute flashes on the display, the time can also be set by pressing HR
button or MIN button on the remote directly. After setting, press TIMER button to confirm.
4. The unit will be turned on automatically at the time you set for the timer.
FM RADIO
TUNING THE FM RADIO
1. Press STANDBY button to turn the unit on.
2. Press FUNCTION button on the unit repeatedly or press FM button on the remote to switch the unit
to FM mode.
3. Press TUNING+/- button to fine tune the radio station. Press and hold TUNING+/- button to
automatically tune the radio frequency forward and backward respectively. When an available station
is found, the unit will broadcast it immediately.
4. Press the PLAY/PAUSE button on the unit or ST/MO button on the remote to switch the radio
between MONO and STEREO.
5. Fully extend the telescopic antenna and adjust its direction for best radio reception.
SAVING FM RADIO STATIONS TO THE UNIT'S MEMORY
1. After tuning the FM radio to the desired stations, press MEM button, a number of a memory cell
flashes on the screen.
2. Press CHANNEL+/- button to select the radio memory cell.
3. Press MEM button again to save the current radio station to the selected memory cell. Up to 20 FM
radio stations can be saved.
4. To recall the preset station frequency, press CHANNEL+/- button repeatedly.
HANDLING AND MAINTENANCE OF A DISC
Follow the instructions below to handle and maintain your disc in order
that long time and trouble free performance can possibly be obtained:
 Ensure not to caress the rain bow side of the disc; handle the disc by
the edge.
 Long time exposure to sunshine, high temperatures and humidity will
damage the disc. And keep storage area clean.
 Avoid sticking labels on both sides of a disc. Writing with pointed
articles on the disc should be strictly avoided.
 Clean the disc wiping the centre and then working out to the edge
with a dry & soft cloth or a disc brush. Avoid any cleansing lotion or
chemical eradicator.
 Store them in their cases when they are not to be used.
LOAD A DISC
1. Open the CD door by pressing the PUSH TO OPEN area.
2. Load a disc on the disc tray with the label side facing outside.
3. Close the CD door.
PLAY A DISC
1. Follow the instructions above to load a disc.
2. Press the FUNCTION button on the unit repeatedly or press CD button on the remote to switch the
unit to CD mode. "READING" shows on the screen to indicate the disc is being read.
3. When the disc is read successfully, playback will start from the first track.
HANDLE DISC ONLY AS SHOWN
CLEAN FROM CENTER TO EDGE
DO NOT STORE NEAR HEAT