Lenco BTS-110 User Manual
Page 4
C. To recharge the built-in rechargeable battery:
You can charge the Bluetooth Speaker’s battery in two ways:
Connect Bluetooth Speaker to the Computer. Or,
Use the USB power charger. (not included)
D. Connection and Charging:
Connect the Bluetooth Speaker’s Micro USB connector with the Computer’s USB port
through USB cable (supplied).
The charging LED turns ON in red light. (make sure that the computer is turned ON)
The charging LED will switch to green light when it’s fully changed.
Disconnect the USB cable when it is done.
Charging LED Function
1.
No DC power input:
LED light OFF
2.
In Charging:
Light On in red color
3.
Charge Completed:
Light color from red switch to green
E. Turn ON/OFF & Play from Bluetooth device:
Slide the power switch to “ON” position to turn on the Bluetooth speaker.
The mode LED indicator (Bluetooth / Aux In) will turn ON and light blue with blink every
half second once, when it is searching Bluetooth devices.
Power & Mode Indicator Function:
Item
Description
Light and Mode Function
Mode Light Status
1.
Power in OFF
Light OFF.
2.
Power in ON
Light ON;
2.a
At Bluetooth searching mode:
Blue light blinking; every half second
once.
2.b
At Bluetooth Paired mode:
Blue light blinking; once per 3 seconds.
2.c
At AUX In Mode:
(3.5 mm jack plugged In)
Light color switch to red color from blue.
Then, activate the Bluetooth function in your Bluetooth device (such as Mobile Phone
or Personal Computer); the device will enter to Bluetooth searching mode
automatically, if not, tap the relate selection to manually enter to searching mode. (refer
to your device’s manual when necessary)
Your Bluetooth device should show “BTS-110” in list, and then select it for pairing.
Waiting for some seconds and you will see connected message as shown on your
Bluetooth device.
For some Bluetooth devices, you may need to input “0000” as pairing password. Once
devices paired, the Bluetooth Speaker will beep twice and the mode LED stays steadily