Lenco BTS-110 - Manual (Page 7)

 Now you can enjoy the music play from your external device through the wire
connection, select to play music from your external device.
 To increase / decrease the music output level from Bluetooth Speaker, adjust the
volume control Up / Down on your external device when using the AUX IN mode.
K. Play to an external power amplifier by AUX OUT:
Bluetooth speaker has design to make your power amplifier device for play music with
an external Bluetooth device through reception by this Bluetooth Speaker. To do this:
 Connect your Bluetooth speaker “AUX OUT” with your external power amplifier
device’s “AUX / LINE Input” through the Audio cable (Supplied). (You can add an
adaptor If RCA jacks used on your power amplifier)
 The Bluetooth Speaker music will cut when you plugged the Audio Cable plug into the
“AUX OUT” jack.
 Switch your external power amplifier function to “AUX / LINE INPUT” mode and then
you will hear the music from your external power amplifier instead of Bluetooth
Speaker. Now enjoy the music with high power sounds via Bluetooth Speaker.
L. Low power reminder and auto sleep:
 The device will send tone sound once in very few sounds, when you listed this remind
sounds from speaker please connect the device to the computer / power charger
through the USB cable If you still want to use the device.
 If not, the Bluetooth Speaker will power off to sleep mode when the battery is keeping
low level in few minutes. In this mode you must need to recharge the built in batter
before you use it again.
3. Trouble Shooting
No power  Check battery is it charged with enough
energy.
 Check whether the device is in power OFF
mode.
No sound
 Check whether volume level is in lower
position on your speaker and mobile phone or
PC/Mac.
 Make sure that your Bluetooth device is within
the effective operation range.
 Check whether the Bluetooth device is paired.
 Check whether the Bluetooth device show
connected.
 Check if you have selected the correct audio
source.