Lenco BTT-100 - Manual (Page 5)

4
RE-CONNECT TO THE BLUETOOTH AUDIO SOURCE DEVICE (UNDER BLUETOOTH MODE)
If the device is already paired with the Lenco BTT-100, but became unconnected even with both
Bluetooth® devices turned on. You can re-connect them by following steps:
1. Press the BT button on the unit or press and hold BT button on the remote to re-link the audio source
device. The Bluetooth® indicator will blink for connecting.
2. Select Lenco BTT-100 on the audio source device for connecting. Bluetooth® indicator will turn to
solid blue if the Lenco BTT-100 and the device have been re-connected successfully.
FM radio operation
TUNING THE FM RADIO
1. Press the POWER ON/OFF button on the unit, then press the STANDBY button to power on the unit.
2. Switch to the radio mode by pressing the MODE button on the unit or FUNTION button on the remote
repeatedly.
3. Press the TUNING+/- button to fine tune radio station. Press and hold the TUNING+/- button to auto
search radio station forward or backward respectively (When an available station is found, the unit
will broadcast it immediately and the searching will stop).
4. During radio playback, press the PLAY/PAUSE button on the remote to switch FM STEREO on or off.
5. During FM radio mode and program service name being displayed, it is able to recall the frequency
and PTY of the current station by pressing and holding VOLUME +/ INFO button on remote control. It
will show the station frequency for 3 seconds, subsequently display PTY in next 3 seconds and then
get back to original program service name display.
STORING YOUR FAVORITE RADIO STATION
1. Tune to your favorite station first; press and hold the MEMORY button on the remote for storing the
current station, memory cell number flashes on the screen.
2. Use the CH+ or CH- button on the remote to select the corresponding memory cell among CH 01 -
CH 20 for storing the station.
3. Confirm your selection by pressing the MEMORY button on the remote.
4. During radio playback, press the MEMORY button and then press the CH+ or CH- button on the
remote repeatedly to recall the stored stations.
USB & SD card operation
1. Power on the unit by following the corresponding instructions.
2. Insert a SD card or a USB onto the unit, and press the FUNCTION button on the remote or MODE
button on the unit repeatedly until toggle the unit to CARD or USB mode.
3. After the unit scans the inserted card or USB, playback will start automatically.
4. Press the RANDOM button on the remote to enable or disable the random playback.
5. Press the PLAY/PAUSE button to pause playback, press this button again to resume normal play.
6. During playback, use the NEXT/PREVIOUS button to skip forward or backward. Press and hold the
FAST FORWARD/BACKWARD button to search through the current track forward or backward.
7. Press the STOP button on the unit or press and hold the STOP button on the remote to cease the
playback.
Sound operation
MUTE THE UNIT
During playback, press the STANDBY/MUTE button on the remote to mute the audio. Press this button