Lenco CR-3304 - Manual (Page 5)

gB 3
TO WAKE TO THE MUSIC
SLIDE THE ALARM SWITCH TO THE AUTO POSITION , THE SyMBOL " " IS SHOWN ON THE
DISPLAy AND ADjUST THE VOLUME CONTROL TO THE LISTENINg LEVEL yOU WANT.
SELECT THE WAKE-UP SOURCE By SLIDINg THE FUNCTION SWITCH TO (FM ST. /FM MONO/CD ).
- IN THE RADIO MODE, THE SELECTED RADIO STATION WILL PLAy.
- IN THE CD MODE, THE DISC LOADED IN THE CD COMPARTMENT WILL PLAy.
- IF NO BUTTON IS PRESSED, ALARM WILL LAST FOR 2 HOURS.
WAKE TO ALARM
TO AWAKEN By ALARM , SET THE ALARM SWITCH TO THE BUZZER POSITION.
THE SyMBOL " " IS SHOWN ON THE DISPLAy.
SNOOZE ( REPEAT ALARM )
WHEN THE ALARM SOUNDS ( CD / RADIO / BUZZER ) AT THE PRESET TIME ,yOU CAN
TURN OFF THE SOUND TEMPORARILy By PRESSINg THE SNOOZE BUTTON . THE
SyMBOL " " IS SHOWN ON THE DISPLAy. THE ALARM WILL SOUND AgAIN WITHIN 9
MINUTES . THIS CyCLE CAN BE REPEATED FOR UP TO ONE HOUR.
TO STOP ALARM ( CD / RADIO / BUZZER )
SIMPLy SET THE ALARM SWITCH TO OFF OR PRESS THE ALARM BUTTON .
THE SyMBOL " " DISAPPEAR ON THE DISPLAy.
SLEEP FUNCTION
1. TO FALL ASLEEP WHILE LISTENINg TO MUSIC, PRESS THE SLEEP BUTTON.
THE SyMBOL " " IS SHOWN ON THE DISPLAy.
2. TO ADjUST THE RADIO'S SLEEP FUNCTION TO PLAy FROM 90 , 60, 30 TO 15 MINUTES OF
MUSIC BEFORE SHUTTINg ITSELF OFF AUTOMATICALLy.
REMOTE TEMPERTURE SENSOR
INSTALL THE REMOTE TEMPERTURE
AFTER INSTALLINg THE BATTERIES, POSITION THE REMOTE SENSOR TO DESIRED OUTDOOR LOCATION
WITHIN THE EFFECTIVE TRANSMISSION RANgE OF 15 METRE. IT CAN BE MOUNTED ON THE WALL By
USINg THE HANgER SLOT AT THE BACK, HANg THE REMOTE SENSOR ON THE WALL WITH THE SCREW.
UNIT STAND
THIS UNIT INCORPORATES A STAND WHICH ALLOWS IT TO BE USED ON A TABLE OR OTHER FLAT SURFACE.
NOTE:
THE SURROUNDINg BUILDINg MATERIALS AND HOW THE MAIN UNIT AND REMOTE SENSOR ARE POSITION
CAN INFLUENCE THE EFFECTIVE TRANSMISSION RANgE.
IT SHOULD BE PLACED AWAy FROM DIRECT SUNLIgHT, RAIN OR SNOW, HIgH POWER ELECTRICAL
APPLIANCE AND STRONg MAgNETIC FIELD SUCH AS SPEAKERS.
OUTDOOR
AFTER BATTERIES ARE INSTALLED, THE REMOTE SENSOR WILL TRANSMIT THE OUTDOOR TEMPERATURE
AT 15 SECONDS INTERVAL. THE MAIN UNIT MAy TAKE UP TO 15 SECONDS TO RECEIVE THE INITIAL
READINgS UPON gOOD SIgNAL RECEPTION. THEN THE MAIN UNIT WILL AUTOMATICALLy UPDATE
READINgS AT TWO-MINUTES INTERVAL. IF NO SIgNAL IS RECEIVED FROM THE REMOTE SENSOR AFTER
10 MINUTES , THE OUTDOOR READINgS WILL NOT BE DISPLAyED PROPERLy. yOU SHOULD PLACE
THE REMOTE SENSOR CLOSER TO THE MAIN UNIT OR REPLACE THE BATTERIES.
CR3304 LENCO ENGLISH FM IM TCD055 5 30/5/2009 12:45:16