Lenco IPD-4300 - Manual (Page 5)

9
Listening to iPod
8
REMOTE CONTROL
VOL+
VOL-
8
10
OK
1
7
6
4
7
9
6
3
5
2
11
1.Infrared Transmitter
2.Standby button ---- To turn the unit
on and off
3.iPod Menu button
4.iPod OK button
5.iPod Play / Pause button
6.iPod Backward / Forward
button
7. VOL + / - button ----- Adjust volume
level up or down
8.iPod Menu Up / Down button
9.iPod Random button
10.Mute button ---- Mute the volume
11.Battery Compartment ---- Located
at the back of the remote control
Accessories
Auxiliary audio signal cable x 1
UM-4 (AAA) battery x 2
Dock Cover x 1
This model adopts different iPod models. Following steps guide you listening
to iPod music.
1.Use the iPod adaptor included in your iPod and insert it into the docking
area. No adaptor required if you use iPhone.
Your iPod can now be inserted into the docking port by placing the
connector on the bottom of the iPod onto connector in the docking bay.
Caution : Please be careful when seating the iPod into the docking to
avoid damaging the 30-pin connector on the iPod or in the
docking system.
2.After applying power to the main unit , the front Standby LED indicator
lights on.
3.Press the Standby button once to turn on the unit and the Standby LED
indicator turns off.
4.Now most of the iPod controls can be implemented by the remote control
unit.
To select iPod menu, press the iPod menu button.
To select item from the iPod menu , press the iPod Menu Up / Down
button.
To confirm item selection, press the OK button.
To start playback music, press the iPod Play / Pause button once.
To pause the music , press the iPod Play / Pause button.
To resume music , press the iPod Play / Pause button again.
You may press the VOL + / - button to adjust the volume to a desired level.
When a song playback, press and hold the iPod Backward / Forward
button to perform high speed search backward / forward.
To skip to previous or next song, press the iPod Backward / Forward
button.
To perform random playback, press the iPod Random button.
To turn off the iPod, press and hold the iPod Play / Pause button around
3 seconds.
To turn off the unit and entering the standby mode, press the Standby
button and the Standby LED indicator will light on.
When the unit is at the standby mode and once the iPod connected to the
docking station, the unit recharges the iPod battery.
Eng Eng