Dixon ZTR 5022 - Manual (Page 43)

TROUBLESHOOTING
MOWER CUT QUALITY:
There are many variables that can affect the cut quality of any riding mower. Type and
conditions of grass, cut height setting, engine RPM and ground speed are some of the variables
that interact creating differences in cut quality. Examination of one or more of the above will
generally produce a quality cut.
The Troubleshooting Chart suggests practices and adjustments that may be helpful in
improving cut quality. Your Dixon ZTR dealer is also available to provide assistance to you.
SITUATION CAUSES REMEDY
Poor cut quality Ground speed Reduce mowing speed
Poor cut quality Incorrect engine to
mower deck belt Refer to page 38 for part numbers
Poor cut quality Engine RPM too low Increase engine RPM to maximum
Poor cut quality Dull or bent blade Sharpen or replace as required
Poor cut quality Un-level mower deck Refer to page 29 for
procedure deck leveling
Poor cut quality Grass buildup under
mower deck Clean out underside of mower deck
Poor cut quality Improper blades Refer to page 38 for part numbers.
Poor cut quality Uneven tire pressures Refer to page 37 for
pressures.
correct tire
Page 41