Lenco SCD-2000 BT - Manual (Page 12)

12
Replacing the battery of the remote control
When the remote control stops working or stops working
properly, the battery should be replaced. Replace the battery as
follows:
1. Press the catch at arrow 1 in the direction of arrow 2 and
hold it.
2. Pull the battery tray out by pulling it in the direction of arrow
2.
3. Replace the battery with a new one and slide the battery tray
back in the remote control. Note that the + side of the battery
is facing up. The model number of the battery is CR2025.
Basic settings
Setting the clock
In standby mode, the device will display the clock on the LCD display (14). You can
set the clock as follows:
1. Make sure the device is in Standby mode.
2. Hold the clock set button (4, 36) for 3 seconds until 12H or 24H appears on the
display (14).
3. Use the previous / next buttons (11, 34) to change the clock display format. You
can select 12 or 24 hours display format. To select the 12 hours display format,
make sure the display shows 12H (14). To select the 24 hours display format,
make sure the display shows 24H (14). Confirm the selection by pressing the
clock set button (4, 36). The device will automatically go to the screen for setting
the clock.
4. Use the previous / next buttons (11, 34) to set the hours. Once the hours are set,
confirm the setting by pressing the clock set button (4, 36). The device will now
automatically switch to the screen for setting the minutes.
5. Use the previous / next buttons(11, 34) to set the minutes. Once the minutes are
set, confirm the setting by pressing the clock set button (4, 36). The device will
now return to the Standby mode and the set time is shown on the display.
Pair & Play™, connecting a Bluetooth® device
Pair & Play™ allows you to connect a Bluetooth® device with a simple press on the
button and it allows you to directly enjoy your favourite music.
1. Turn on the device by pressing the Power button (13, 24).
2. Switch to the Bluetooth® mode by repeatedly pressing the source button (3, 29).
Once the display (14) shows blue, the device is in the Bluetooth® mode.