Lenco SR-600 BT - Manual (Page 6)

E-5
Backup Batteries
Batteries are preloaded in the unit. Remove the insulation tab from the battery
compartment to activate the battery back-up before first use.
To replace the batteries, carefully open the battery door of the BATTERY BACK-UP
COMPARTMENT (#21). Remove the old batteries and follow the polarity marking to
insert 2 x new LR44/AG13 button cells into the compartment and close the battery door.
BATTERY WARNING
1. Be sure that the batteries are installed correctly. Wrong polarity may damage the
unit.
2. Use only the size and type of batteries specified.
3. Do not mix old and new batteries.
4. Do not mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium)
batteries.
5. If the unit is not to be used for an extended period of time, remove the batteries.
Old or leaking batteries can cause damage to the unit and may void the warranty.
6. Do not try to recharge batteries not intended to be recharged; they can overheat
and rupture. (Follow battery manufacturer’s directions).
7. Do not dispose of batteries in fire, batteries may leak or explode.
NOTE: These speakers are not magnetically shielded and may cause color distortion
on the screen of some TVs or video monitors. To avoid this, you may need to move the
speakers further away from the TV or monitor if unnatural color shifts or image
distortion occurs.
TURN THE UNIT POWER ON/OFF
Power on/off the unit
When using either the AC adaptor or battery, first slide the MAIN POWER ON/OFF
SWITCH (#15) on the back of the unit to the ON position. The POWER INDICATOR
(#19) will turn on, LED DISPLAY (#12) will turn on and display the time.
Press and hold the FUNCTION/ button (#10) to turn the SR-600 BT to On or
Standby.
To switch off the unit, slide the MAIN POWER ON/OFF SWITCH (#15) to OFF position.
CLOCK SETTING
Note: When you turn the unit on for the first time, 12:00 will show on the LED display
and flashing.
1. In standby mode, press and hold the PRESET/TIME SET button (#2), the hour
digits will flash.
2. Tap the button (#4) or button (#5) to adjust hour. Press and hold the
button (#4) or button (#5) for fast reverse/advance setting.
3. Tap the PRESET/TIME SET button (#2) to confirm the hour setting, the minute
digits will flash to prompt for input.
4. Tap the button (#4) or button (#5) to adjust minute. Press and hold the
button (#4) or button (#5) for fast reverse/advance setting.
5. Tap the PRESET/TIME SET button (#2) to complete the setting.