Lenco SR-600 BT - Manual (Page 7)

E-6
NOTE: The clock settings may be lost if the main power switch is turned off and the
battery drains after a period of time. If this occurs, you will need to reset the clock.
LISTENING TO THE RADIO
1. Press and hold the button (#10) to turn on the unit.
2. Tap the button (#10) to select Radio mode, the radio frequency
will show on LED Display (#12).
3. Press and hold the button (#4) or button (#5) to search for the next /
previous available station. If the reception is poor, try Manual Tuning to fine-tune
the station.
4. Press the button (#4) or button (#5) briefly to manually tune through
the frequency band.
5. Adjust the volume control to the desired volume level.
6. If no button is pressed for 5 seconds in radio mode, the display will change to
show current time. You can tap the button (#4) or button (#5) to check
the tuned frequency.
7. Press and hold the button to turn the unit into Standby mode after
listening.
8. Always slide the Power switch to the OFF position when not in use to prevent
draining the internal battery.
FM Mono & FM-Stereo reception
- Press the FM ST/MONO button (#3) to select stereo mode, the LED Display (#12) will
show “St” a few seconds and then resume to show the frequency.
- It is preferable to receive the program in mono when you are receiving a weak station.
Press the FM ST/MONO button (#3) to select Mono mode, the LED Display (#12) will
show “St OF” a few seconds and then resume to show the frequency.
TIPS FOR BEST RADIO RECEPTION:
To insure maximum FM tuner reception, fully extend the TELESCOPIC ANTENNA (#1)
for best FM radio reception.
Setting the Radio Station Presets
The SR-600 BT allows you to store up to 30 stations for easy recall at any time.
1. Press and hold the button (#10) to turn on the unit.
2. Tap the (#10) button to select radio mode.
3. Tune to the radio station either you want to store in memory.
4. Press and hold the PRESET/TIME SET button (#2). The preset channel number
“P01” will be flashing on display
.
5. Tap the button (#4) or button (#5) to select the preset number (P01-P30).
6. Tap the PRESET/TIME SET button (#2) to confirm.
7. To store up to 30 station presets, repeat steps 3 to 6 above.