Lenco TS-10 - Manual (Page 5)

4
Connect to TV
This unit is very user friendly, please just
connect it directly to TV’s headphone
jack as below :
1 Connect the LINE IN cable to:
- LINE IN socket on the unit.
- HEADPHONE socket on TV.
2 Unit turn on automatically. Press
the /SOURCE button to select
source.
3 Turn on your TV.
Tip:
You can simply use your TV’s
inherent Remote Control set to
control Vol+/Vol-.
Connect Power
Caution:
- Risk of product damage!
- Ensure that the power supply voltage
corresponds to the voltage printed on
the back or the underside of the unit.
Connect the AC power cord to:
- the AC ~ socket on this unit.
- the wall socket.
Turn On/Off
W h e n y o u c o n n e c t T V o r a n
external device to the unit, unit will
turn on automatically. Auto Power
indication light is green (connect
to LINE IN 1) or yellow (connect to
LINE IN 2). And will turn red when
disconnected or when you turn off
TV / external device.
NOTE:
If the volume of TV or an external
device is too low, the unit also turn
off automatically.
Adjust Volume Level
During play, press the VOLUME+/-
buttons to increase/decrease the
volume level.
If the unit is connected to the TV’s
headphne jack, you can also
control the Volume Level by using
the TV’s remote control set directly.
Connections