Lenco TS-10 - Manual (Page 6)

5
Troubleshooting
To keep the warranty valid, never try
to repair the system yourself. If you
encounter problems when using this
unit, check the following points before
requesting service.
No power
- Ensure that the AC cord of the
apparatus is connected properly.
- Ensure that there is power at the
AC outlet.
- Press standby button to turn the
unit on.
No Response From the Unit
- Disconnect and reconnect the AC
power plug, then turn on the unit
again.
Specifications
General
Power Requirements . AC 230V ~ 50Hz
Power Consumption .................... 6.5W
Output Power ..............7.5W x 2 + 15W
Total Harmonic Distortion .....................
..........................................1%(1kHz, 1W)
Audio Input Sensitivity/Impedance
LINE: ................................ 500mV/47kΩ
Frequency Response ............................
......................... 40Hz - 20kHz(+0 / -3dB)
Unit Dimensions (W x H x D) ..................
.................................. 584 x 50 x 218mm
Speaker
Front
Impedance ......................................3 Ω
Rate Power .................................... 10W
Subwoofer
Impedance ......................................6 Ω
Rate Power .................................... 30W
If at any time in the future you should
need to dispose of this product
please note that: Waste electrical
products should not be disposed of
with household waste. Please recycle
where facilities exise. Check with
your Local Authority or retailer for
recycling advise. (Waste Electrical
and Electronic Equipment Directive.)