Denon RCD-M38 - Manual (Page 20)

ENGLISH
17
Getting Started
Basic Connections
Basic Operations
Advanced Operations Advanced Operations
Troubleshooting
Explanation terms
Specifi
cations
Index
Advanced Connections
Advanced Operations
Preparations
Before playing control dock for iPod
1 Set the iPod on the DENON control dock for
iPod.
(vSee the control dock for iPod’s operating instructions.)
2 Press ON/STANDBY .
3 Press SOURCE to select “AUX1/Dock”.
Before playing a USB or an iPod
1 Press ON/STANDBY .
2 Connect USB memory device or iPod connection
cable.
When the USB memory device or iPod is connected to the USB
port on this unit, the source automatically switches to “USB”
and fi le playback begins.
n Turning the power off (to the standby mode)
Press ON/STANDBY again.
NOTE
Be sure to stop playback before turning the power off.
MP3 or WMA playback order of MP3 or
WMA fi les
When there are multiple folders containing MP3 or WMA fi les, the
playback order of folders is automatically set when this unit reads the
media. The fi les in each folder are played back in the order in which
the fi les were recorded on the media, from the oldest date and time.
n Playback order of folders
CD-R/CD-RW
For playback of fi les on CD-R or CD-RW , fi les in all folders on the fi rst
layer are played fi rst, next on the second layer, then next on the third
layer, and so on in this order.
USB memory device
For playback of fi les recorded on USB, fi les in the fi rst folder on the
fi rst layer are played fi rst, next folders on the second layer in the folder,
then next on the third layer, and so on in this order. Then accordingly
fi les on another fi rst layer are played.
• The playback order displayed on a PC may differ from the actual
playback order.
• The playback order with a CD-R/CD-RW may differ, depending on
the writing software.
NOTE
The playback order may differ from the order in which the folders
or fi les were recorded if you delete or add a folder or fi le on USB.
This occurs because of data recording specifi cations and is not a
malfunction.
Button located on both the main unit and the remote control
BUTTON
Button only on the main unit <BUTTON>
Button only on the remote control [BUTTON]
Symbols used to indicate buttons in this manual
<1/3>
ON/STANDBY SOURCE
ON/STANDBY
[ENTER/MEMO]
[FOLDER MODE]
[CD 1/3]
[NUMBER]
[8, 9]
SOURCE
[REPEAT]
[TIME/DISPLAY]
[o p]
[FOLDER +, –]