Altera Arria V GX User Manual
Page 22
5–2
Chapter 5: Board Update Portal
Using the Board Update Portal to Update User Designs
Arria V GX Starter Kit
November 2014
Altera Corporation
User Guide
f
You can also navigate directly to the
the Altera website
to determine if you have the latest kit software.
Using the Board Update Portal to Update User Designs
The Board Update Portal allows you to write new designs to the user hardware 1
portion of flash memory. Designs must be in the Nios II Flash Programmer File
(.flash) format.
1
Design files available from th
page include .flash files. You
can also create .flash files from your own custom design. Refer to
Files for Flash Programming” on page A–2
for information about preparing your own
design for upload.
To upload a design over the network into the user portion of flash memory on your
board, perform the following steps:
1. Perform the steps in
“Connecting to the Board Update Portal Web Page”
to access
the Board Update Portal web page.
2. In the Hardware File Name field, specify the .flash file that you either
downloaded from the Altera website or created on your own. If there is a software
component to the design, specify it in the same manner using the Software File
Name
field; otherwise, leave the Software File Name field blank.
3. Click Upload. The progress bar indicates the percent complete.
4. To configure the FPGA with the new design after the flash memory upload process
is complete, set the FAC_LOAD (SW4.3) to the user on (0) position, and power
cycle the board
.
1
As long as you don’t overwrite the factory image in the flash memory device, you can
continue to use the Board Update Portal to write new designs to the user hardware 1
portion of flash memory. If you do overwrite the factory image, you can restore it by
following the instructions in
“Restoring the Flash Device to the Factory Settings” on
.