The flash tab, Read, Write – Altera Cyclone V GX FPGA User Manual
Page 23: The flash tab –7, Read –7 write –7
Chapter 6: Board Test System
6–7
Using the Board Test System
October 2012
Altera Corporation
Cyclone V GX FPGA Development Kit
User Guide
The Flash Tab
The Flash tab allows you to read and write flash memory on your board.
shows the Flash tab.
The following sections describe the controls on the Flash tab.
Read
The Read control reads the flash memory on your board. To see the flash memory
contents, type a starting address in the text box and click Read. Values starting at the
specified address appear in the table.
1
If you enter an address outside of the flash memory address space, a warning
message identifies the valid flash memory address range.
Write
The Write control writes the flash memory on your board. To update the flash
memory contents, change values in the table and click Write. The application writes
the new values to flash memory and then reads the values back to guarantee that the
graphical display accurately reflects the memory contents.
Figure 6–3. The Flash Tab