Altera Cyclone V GX FPGA - Manual (Page 35)

Appendix A: Programming the Flash Memory Device A–5
Restoring the MAX V CPLD to the Factory Settings
October 2012 Altera Corporation Cyclone V GX FPGA Development Kit
User Guide
nios2-terminal
r
and follow the instructions in the terminal window to generate a unique MAC
address.
f To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Cyclone V GX FPGA Development Kit page of the
Altera website.
Restoring the MAX V CPLD to the Factory Settings
This section describes how to restore the original factory contents to the MAX V
CPLD on the FPGA development board. Make sure you have the Nios II EDS
installed, and perform these steps:
1. Set the board switches to the factory default settings described in “Factory Default
Switch Settings” on page 4–2 .
1 DIP switch SW5.1 includes the MAX V device in the JTAG chain.
2. Launch the Quartus II Programmer.
3. Click Auto Detect.
4. Click Add File and select <install
dir>\kits\cycloneVGX_5cgxfc7df31_fpga\factory_recovery\max5.pof.
5. Turn on the Program/Configure option for the added file.
6. Click Start to download the selected configuration file to the MAX V CPLD.
Configuration is complete when the progress bar reaches 100%.
f To ensure that you have the most up-to-date factory restore files and information
about this product, refer to the
Cyclone V GX FPGA Development Kit page of the
Altera website.