Altera Cyclone V SoC - Manual (Page 31)

Chapter 5: Board Test System 5–13
Using the Board Test System
November 2013 Altera Corporation Cyclone V SoC Development Kit
User Guide
The HSMC Tab
The HSMC tab allows you to perform loopback tests on the XCVR, LVDS, and CMOS
ports.
Figure 5–7 shows the HSMC tab.
1 This tab requires that a bts.ini file with QTS=ON specified at the 1st line reside in the
same directory as BoardTestSystem.exe. Removing or renaming this file will run an
older version of this tab, which is grayed out by default. See the readme.txt in that
same directory for more information.
1 You must have the loopback HSMC installed on the HSMC Port A connector for this
test to work correctly.
The following sections describe the controls on the HSMC tab.
Start, Stop
The Start and Stop controls at the bottom-right of this tab allow you to start and stop
testing for all three ports.
Figure 5–7. The HSMC Tab