Immobilizer (turbo models) – Subaru 2006 Impreza WRX User Manual

Page 90

Advertising
background image

Keys and doors

2-3

– CONTINUED –

Immobilizer (Turbo models)

The immobilizer system is designed to

prevent an unauthorized person from

starting the engine. Only keys registered

with your vehicle’s immobilizer system

can be used to operate your vehicle. Even

if an unregistered key fits into the ignition

switch and can be turned to the “START”

position, the engine will automatically stop

after several seconds.
Each immobilizer key contains a tran-

sponder in which the key’s ID code is

stored. When a key is inserted into the ig-

nition switch and turned to the “ON” posi-

tion, the transponder transmits the key’s

ID code to the immobilizer system’s re-

ceiver. If the transmitted ID code matches

the ID code registered in the immobilizer

system, the system allows the engine to

be started. Since the ID code is transmit-

ted and acted upon almost instantly, the

immobilizer system does not impede nor-

mal starting of the engine.

If the engine fails to start, pull out the key

once before trying again. (Refer to the “Ig-

nition switch” section [chapter 3].)
This device complies with Part 15 of

the FCC Rules and with RSS-210 of In-

dustry Canada. Operation is subject to

the following two conditions: (1) This

device may not cause harmful interfer-

ence, and (2) this device must accept

any interference received, including in-

terference that may cause undesired

operation.

Changes or modifications not express-

ly approved by the party responsible

for compliance could void the user’s

authority to operate the equipment.

NOTE

To protect your vehicle from theft,

please pay close attention to the fol-

lowing security precautions:

Never leave your vehicle unattended

with its keys inside.

Before leaving your vehicle, close all

windows and lock the doors and rear

gate.

Do not leave spare keys or any

record of your key number in the vehi-

cle.

Security ID plate

1) Key number plate

2) Security ID plate

The security ID is stamped on the metal

plate attached to the key set. Write down

the security ID and keep it in another safe

place, not in the vehicle. This number is

needed to make a replacement key if you

lose your key or lock it inside the vehicle.

This number is also needed for replace-

ment or repair of the engine control unit,

immobilizer control unit.

Security indicator light

The security indicator light deters potential

thieves by indicating that the vehicle is

equipped with an immobilizer system. It

Do not place the key under direct

sunlight or anywhere it may be-

come hot.
Do not get the key wet. If the key

gets wet, wipe it dry with a cloth

immediately.

1

2

200803

Advertising