Subaru 2003 Legacy - Manual (Page 204)

5-20
band has been scanned from the low end to the high end.
Press the “SCAN” button again to cancel the SCAN mode and to stop
on any displayed frequency.
When the “SCAN” button is pressed for automatic tuning, stations are
scanned in the direction of low frequencies to high frequencies only.
Automatic tuning may not function properly if the station reception is
weakened by distance from the station or proximity to tall buildings and
hills.
B
Selecting preset stations
Presetting a station with a preset button
6
allows you to select that
station in a single operation. Up to six AM, FM1, FM2 and WB stations
each may be preset.
B
How to preset stations
1. Press the “FM/AM” selection button to select AM, FM1 or FM2 re-
ception.
OR
Press the “WB” button
5
to select the weather band.
2. Press the “SCAN” button
8
or tune the radio manually until the de-
sired station frequency is displayed.
3. Press one of the preset buttons
6
for at least 1.5 seconds to store
the frequency. The frequency of the station will flash once on the dis-
play at this time. If the button is pressed for less than 1.5 seconds, the
preceding selection will remain in memory.
NOTE
If the connection between the radio and battery is broken for any
reason such as vehicle maintenance or radio removal, all stations
stored in the preset buttons are cleared. If this occurs, it is neces-
sary to reset the preset buttons.