Foward-facing child restraint installation, Using the seat belts — front passenger and, Passenger’s side jump seat – NISSAN 2010 Frontier User Manual
Page 63: King cab models only) -45
8. Tighten the tether strap according to the
manufacturer’s instructions to remove any
slack.
9. Check to make sure the child restraint is
properly secured prior to each use. If the
seat belt is not locked, repeat steps 3
through 7.
10. If the child restraint is installed in the front
passenger seat, place the ignition switch in
the ON position. The front passenger air bag
status light
should illuminate. If this
light is not illuminated see
ЉFront passenger
air bag and status light
Љ in this section.
Move the child restraint to another
seating position. Have the system
checked by a NISSAN dealer.
After the child restraint is removed and the seat
belt is fully retracted, the ALR mode (child re-
straint mode) is canceled.
FOWARD-FACING CHILD
RESTRAINT INSTALLATION USING
THE SEAT BELTS — FRONT
PASSENGER AND PASSENGER’S
SIDE JUMP SEAT (King cab models
only)
Forward-facing – step 11
WRS0475
LRS0598
Safety—Seats, seat belts and supplemental restraint system
1-45