BINDER CB 60 - Manual (Page 28)

CB (E6) 09/2013 Page 28/144
General information for safe handling of oxygen:
•
Make sure training of personnel on hazards of oxygen enrichment and necessary safety
measures.
• Make sure adequate labeling of all oxygen equipment and facilities.
• Make sure gas tightness of all gas connections by checking them for leaks (e.g. with leak
spray or diluted soap solution).
• Close the main valve of the source of oxygen after work when not using the chamber.
• Never lubricate O
2
equipment with oil or fat. Use only materials and spare parts which are
approved for use with oxygen.
• Regularly inspect fire extinguishers for proper condition.
• Set up emergency showers where oxygen enrichment is possible.
• Strictest smoking ban and no ignition sources in areas where oxygen enrichment is
possible.
• Make sure good ventilation of areas where oxygen enrichment is possible (location of the
chamber and/or O
2
cylinders.
• Persons who may have been in a possibly oxygen-enriched atmosphere must keep away
from ignition sources (flames, cigarettes, etc.) and ventilate their clothes at least 15
minutes.
• Always keep emergency routes free.
Unit with O
2
control: Notes on handling nitrogen (N
2
)
Nitrogen (N
2
) in high concentrations is hazardous to health. It is colorless and almost odorless and
therefore practically imperceptible. Any N
2
gas that may escape must be safely led out via good room
ventilation or a suitable connection to an exhaust system.
WARNING
High concentration of N
2
.
Risk of death by suffocation.
∅
Do NOT set up units in non-ventilated recesses.
 Ensure technical ventilation measures.
 Observe the relevant regulations for handling N
2
.