BINDER FDL 115 - Manual (Page 66)

FDL (E2.1) 02/2015 page 66/75
Interior dimensions
Width mm / inch 600 / 23.62
Height mm / inch 435 / 17.13
Depth mm / inch 435 / 17.13
Interior volume l / cu.ft 115 / 4.1
Number of racks, chrome-plated (regular / max.) 2/5
Load per rack Kg /lbs 30 / 66
Permitted total load Kg /lbs 60 / 132
Weight of the unit (empty) Kg /lbs 88 / 194
Temperature data
Temperature range, 10 °C above ambient up to °C / °F 300 / 572
Maximum temperature of the heating surface °C / °F 750 / 1382
Maximum permitted oven temperature °C / °F 300 / 572
Temperature fluctuation at 150 °C / 302 °F ± K 0.8
Temperature uniformity (variation)
at 50 °C / 122 °F ± K 0.5
at 150 °C / 302 °F ± K 2.5
at 300 °C / 572 °F ± K 5.8
Heating-up time 2)
to 50 °C / 122 °F min 10
to 150 °C / 302 °F min 18
to 300 °C / 572 °F min 63
Recovery time after door was opened
for 30 sec. 2)
to 50 °C / 122 °F min 12
to 150 °C / 302 °F min 7
to 300 °C / 572 °F min 14
Ventilation data
Air circulation approx. x/min. 20
Air change acc. to EN 1539:2009 at 50 °C approx. x/min. 2.5
Volumetric flow rate of exhaust air acc. to EN 1539:2009
at 50 °C 3)
approx. l/min 400
approx. m 3 /h 24.0
Solvent data
Highest permitted solvent quantity acc. to EN 1539:2009
4)
(at T-180 °C, M-100g/mol, U-40g/m3, K=0,5)
g 6.65
Electrical data
Housing protection acc. to EN 60529 IP 33
Nominal voltage (+5 %) V 230 1 N ~
Power frequency Hz 50/60
Nominal current Amp 13.0
Nominal power kW 2.90
Sound-pressure level dB(A) 57
Energy consumption 5) at 150 °C / 302°F Wh/h 1098
Power plug shock proof plug
Over-voltage category acc. to IEC 61010-1 II
Pollution degree acc. to IEC 61010-1 2
Legend:
1) If the volume of the drying material inserted in the dryer exceeds 10% of the total steam area, it must
be deducted in the calculation of the total steam volume.
2) Values without considering the prepurge time
3) Procedure: "calculation of the volumetric flow rate through the exhaust duct based on the velocity of
flow measured there with a propeller anemometer"