d&b D80 Touring rack NEMA L21-30 - Manual (Page 8)

3.3.3. 4 CH OUTPUTS - NL8
NOTICE!
The 4 CH OUTPUTS connectors are only intended as an interface
to a rack panel or to loudspeaker multicores such as d&b
Z5343.xxx and breakout adapters such as d&b Z5347.xxx.
Do not connect any loudspeaker cabinets, neither passive nor
active systems, to the 4 CH OUTPUTS connectors, otherwise there
is a risk of damaging the loudspeaker components or the amplifier.
Each of the 4 CH OUTPUTS connectors represents the 4
CHANNEL OUTPUT of the respective D80 amplifier. Each
connector carries the output signals of all four channels of the
amplifier with the following pin assignment.
1+/— = Channel A pos. / neg. 2+/— = Channel B pos. / neg.
3+/— = Channel C pos. / neg. 4+/— = Channel D pos. / neg.
Please refer to the corresponding channel assignment label above
each connector as shown in the graphic opposite.
3.3.4. 6 CH OUTPUTS6 CH OUTPUTS - LKS 19 F
The 6 CH OUTPUTS multipin connectors (LKS 19) are used in
connection with the d&b Z5320.xxx cabling system to allow
efficient system wiring using loudspeaker multicore cables.
Each connector carries the output signal of six amplifier channels.
Please refer to the corresponding channel assignment label above
each connector as shown in the graphic opposite.
d&b Z5330.050 Manual 1.1 en 8