d&b Z5147 Rota Clamp - Manual (Page 3)

Z5147 Rota Clamp
Fig. 1: Z5147 Rota Clamp
1. Product description
Using the Z5147 Rota Clamp loudspeaker arrays or single cabinets can
be suspended and horizontally aligned from a single flying point. The
Rota Clamp allows the load to be attached to overhead bars or truss
with a tube diameter up to 51 mm (2”). It can be used in combination
with the following d&b rigging accessories:
Z5020 Flying adapter 02
Z5121/22 Flying frame 02 90°/60°
Z5044 Bracket connector
Z5145 Ci Mounting frame
Z5054 Ci Flying adapter
Z5156 Q Flying adapter
Z5159 Q Flying frame
Observe the maximum permitted load of the respective accessories as
stated in their respective manuals/mounting instructions.
Ø 30
Ø 50
155.4
145.4
Fig. 2: Z5147 Rota Clamp
Installation height
2. Scope of supply
The Z5147 Rota Clamp is pre assembled and supplied together with this
mounting instructions.
3. Load safety information
The maximum permitted load of the Z5147 Rota Clamp
is 500 kg/1100 lb according to the German standard
BGV C1. No additional loads must be added.
Never fit the clamp at an angle other than straight down.
4. Weight/Installation height
Weight..............................................................................................................2.2 kg/4.9 lb
Installation height.........155.4 mm/6", related to a tube diameter of 30 mm/1.2"
..........................................145.4 mm/5.7", related to a tube diameter of 50 mm/2"
5. Assembly
Safety precautions
The Z5147 Rota Clamp must only be used to suspend d&b loudspeaker
cabinets from a single suspension point in conjunction with the
recommended d&b rigging accessories.
Installation should only be carried out by fully trained personnel. There
are certain rules for installation that must be complied with.
It is the responsibility of the person installing the assembly to ensure that
the structure being attached to is suitable for the intended use.
All system components must be inspected for faults before use. Please
pay attention to section 8. Maintenance and care on page 7. Damaged
components must be withdrawn from use immediately.
Z5147 Mounting instructions (2.2 EN) Page 3 of 8