d&b Z5147 Rota Clamp - Manual (Page 5)

[2]
Fig. 6: Installation - Step 1
1 First release the hand wheel [2] of the clamping lever until its end-
position.
Fig. 7: Installation - Step 2/3
2. Fold out the clamping lever.
3. With the support clamp open, the assembly can now be lifted into
position.
Fig. 8: Installation - Step 4
4. Close The two halves of the clamp around the bar.
[U]
[2]
Fig. 9: Installation - Step 5/6
5. Pull back the U-washer [U] of the clamping lever to the hand wheel
[2].
6. Fold back the clamping lever.
Fig. 10: Installation - Step 7
7. Hand-tighten the hand wheel [2].
Safety precaution!
No other adjustments should be attempted until the
hand wheel has been tightened.
A safety wire (secondary safety) should now be fitted to
secure the assembly before carrying out either positional
or directional adjustments.
Z5147 Mounting instructions (2.2 EN) Page 5 of 8