d&b Z5356 E4 Ball joint adapter - Manual (Page 5)

Attaching the ball joint adapter to the cabinet
1. Attach the ball joint adapter to the M10 threaded insert on the
rear panel of the cabinet.
2. Fix the adapter to the cabinet by tightening the locking device
[C] accordingly.
Alternatively an open-ended spanner (size #17) can be used
for this purpose.
1.4. Z5038 Fixing plate M10
The Z5038 Fixing plate M10 can be used to mount the E4 or E5
cabinets to walls, ceilings or other surfaces.
Note: Refer to the respective mounting instructions which are
supplied together with the fixing plate.
If the cabinets are mounted to a wall, both horizontal or vertical
mounting is possible. If the cabinets are mounted to a ceiling, the
horizontal setup is recommended.
The following mounting options and angle settings are applicable
no matter whether the cabinets are mounted to walls or ceilings or
other suitable surfaces.
E4 loudspeaker
For the E4 cabinet, angles can be set from 0° to –50° (vertical
setup) or from 0° to –80° (horizontal setup).
E5 loudspeaker
For the E5 cabinet, angles can be set from 0° to –35° (vertical
setup) or from 0° to –75° (horizontal setup).
d&b Z5356 E4/E5 Ball joint adapter , Mounting instructions (1.2 EN) 5