d&b Z5354 E8 - Manual (Page 4)

2. Intended use
Application example E12/E12-D
The Z5354, E8/E12 Flying adapter and the Z5355 E8/E12 Flying
adapter link must only be used in conjunction with the d&b E-Series E8
and E12 (E12-D), T-Series T(i)10 (in Point source mode) or Y-Series
Y(i)7P/Y(i)10P loudspeakers as described in these mounting instructions.
Installation and setup should only be carried out by qualified and
authorized personnel observing the valid national Rules for the
Prevention of Accidents (RPA).
It is the responsibility of the person installing the assembly to ensure that
the suspension/fixing points are suitable for the intended use.
The Flying adapter can be used:
– together with the supplied 1 to. Shackle to be suspended using
a steel wire rope or chain.
– together with the Z5015 TV spigot and Z5012 Pipe clamp to
be attached to overhead bars or trusses with a tube diameter
up to 51 mm (2”).
Alternatively the Z5147 Rota Clamp can be used.
– together with the Z5355, E8/E12 Flying adapter link to set up
a vertical array of maximum of two cabinets.
NOTICE: Observe the maximum permitted load of the related
accessories as stated in the respective manuals/mounting
instructions.
3. Safety precautions
General safety
Always carry out a visual and functional inspection of the components
before use. If there is any doubt as to the function and safety of the
components, do not use them. Please also refer to section
7. Maintenance and care on page 8.
Load safety information
The maximum permitted working load of the adapter corresponds to a
weight of max. two loudspeakers listed above, to be flown one below
the other.
4. Attaching the Flying adapter to the cabinet
The Flying adapter can be attached in two directions (1 and 2 - as
shown in the graphic opposite) and is directly bolted to the M10
threaded inserts of the cabinet's top or bottom panel.
Tools required: Open ended spanner/wrench (size #17).
1. Attach the Flying adapter to the threaded inserts of the cabinet.
2. Screw in the two hex head bolts until they are hand tightened.
3. Finally tighten the screws.
Z5354/Z5355, Mounting instructions (1.3 EN) Page 4 of 10