d&b Z5385 V Flying adapter - Manual (Page 6)

2.2. Preparing the setup
General
Check the acoustical and mechanical setup using ArrayCalc and
prepare enough printouts for each array.
The plan enables the riggers to set up the suspension points, the
securing points and the chain hoists.
When on site first:
– Clear the working areas and ensure there is enough space to
set up and lift the array.
– Check that the hoists are exactly in the specified position.
– Ensure the chains are not twisted.
– Prepare the cables and link cables according to the number of
amplifier channels and cabinets used.
Inspections before setup
Before setup carry out a visual inspection of all system components
for faults. This also includes the loudspeaker and in particular the
rigging parts of the cabinets (Front and Splay/Rear links).
Damaged components must be withdrawn from use immediately.
Please follow the instructions given in Þ Chapter 3. "Care and
maintenance / Disposal" on page 10.
2.3. Order of assembly
Due to the compact size of the V-Series TOP cabinets and the
maximum number of four cabinets that can be flown, the assembly
may be carried out either suspended or on the ground. The
following description refers to the suspended assembly.
1. Prepare the first cabinet
1. At the front release both Locking pins and slide out the Front
link.
2. Insert and lock one Locking pin to fix the link in place.
3. On the rear release both Locking pins and fold out the Splay
link.
d&b Z5385 V Flying adapter, Rigging manual (1.3 EN) 6