Future Automation PICSIDE - Manual (Page 6)


Before you Start Check, Check the Following:
- The product is in good condition
- No damage to any parts
In
st
al
la
ti
o
n
:
S
ta
ge
1
Page 5 of 20 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565
PIC SD - Picture Side Mechanism
You will receive your mechanisms with the wall plate in the centre of the frame.
This is in the easiest position to mount straight onto the wall.
Start by marking where the mechanism will go on the wall. Mark centre points through
both the key hole slots, shown in the right detail view. Make sure the mechanism is
level using a spirit level.
Refer to the Tech Sheets
for further dimensions
25mm [1]
Marking Mechanisms Positions
These dimensions can differ depending on the moving panel frame work.