ILUMINARC Ilumipanel™ 180 IP - Manual (Page 14)

Operation
10 Ilumipanel 180 IP Optic 15/30 RGBWA User Manual Rev. 12
To assign
individual DMX
addresses to each
product, you must connect
the Ilumicode addresser to
each product, individually.
The Ilumicode will
not work via
wireless. You must
hardwire the Ilumicode
directly to the Ilumipanel
180 IP Optic 15/30
RGBWA when
programming the product.
ILUMINARC®
suggests that you
connect no more than 20
products together at one
time with this controller and
keep the total distance to
less than 60 m (197 ft).
Otherwise, you might need
to use an optically isolated
signal amplifier.
ILUMICON
The Ilumipanel 180 IP Optic 15/30 RGBWA can also work with the ILUMICON
controller instead of a standard DMX controller. Please refer to the ILUMICON User
Manual to learn how to use this controller with the Ilumipanel 180 IP Optic 15/30
RGBWA products. The following figure illustrates how to connect the ILUMICON
controller to the Ilumipanel 180 IP Optic 15/30 RGBWA.
Ilumicode
The Ilumicode addresser (version 2.2 or higher) is required to program the settings on
the Ilumipanel 180 IP Optic 15/30 RGBWA. The following diagram shows how to
connect the Ilumicode addresser to this product.
This connection will control multiple products at the same time. In addition, all
connected products will be assigned to the same DMX address
Important: The Ilumicode must be used to configure this product. The Ilumicode
can be purchased separately through your Iluminarc sales representative.