ILUMINARC Ilumipanel™ 180 IP - Manual (Page 22)

Technical Information
18 Ilumipanel 180 IP Optic 15/30 RGBWA User Manual Rev. 12
5. Technical Information
Always dry the
external optics
and glass
surfaces carefully
after cleaning them.
If you still
experience
technical
problems after
trying the solutions in the
Troubleshooting Table,
contact ILUMINARC
®
Technical Support.
Product Maintenance
To maintain optimum performance and minimize wear, the user should clean the products
frequently. Usage and environment are contributing factors in determining the cleaning
frequency. As a rule, the user should clean the products at least twice a month. Dust build up
reduces light output performance and can cause overheating. This can lead to reduced light
source life and increased mechanical wear.
To clean a product, follow the below recommendations:
· Disconnect the product from power.
· Wait until the product has cooled.
· Use a vacuum (or dry compressed air) and a soft brush to remove dust collected on the
product.
· Clean all external glass optics and glass surfaces with a mild solution of glass cleaner or
isopropyl alcohol, and a soft, lint-free cotton cloth or a lens cleaning tissue.
· Apply the solution directly to the cloth or tissue and drag any dirt and grime to the outside
of the lens.
· Gently polish the external glass surfaces until they are free of haze and lint.
Product Repairs
ILUMINARC ® strongly advises you against attempting any repairs to this product unless you
are an authorized ILUMINARC ® technician.
ILUMINARC ® presents the information contained in the Troubleshooting Table as a guide
only. In most cases, opening the product’s housing will invalidate its warranty, unless there is a
written indication to the contrary.