Junger Audio D*AP8 Digital Audio Processor - Manual (Page 29)

D*AP8
27
Group 1 – 4 The embedding process distinguishes between 4 different modes for each
group independently:
Embedding – a new group will be built
Replace – the structure of the group from the input is kept and the audio
content is simple replaced
Delete – the group from the input is deleted
OFF – the embedder fro that group is turned off
VANC Metadata [Enabled - / Disabled – (selected SDID#)]
Embedder Status For details see SMPTE 2020-2 standard.
ARIB STD-B39 Meta information standard
Control Data Status
Status [Available / Not Available]
Audio Mode See ARIB Japanese standard "Structure of Inter-Stationary Control Data
Conveyed by Ancillary Data Packets"
http://www.arib.or.jp/english/html/overview/doc/2-STD-B39v1_2.pdf
Setup GUI – INTERFACES – SDI I/O interface – Local Routing
The SDI interface comes with a local routing matrix to shuffle audio signals from and to the system (device)
(i.e. to and from the central device router) and from and to the physical de-embedders / embedders.
The example below shows the default routing that sends all signals 1:1 from the physical de-embedders
[INTERFACE – SDI IN G1 CH1 … SDI IN G4 CH4] to the internal device matrix
[SYSTEM – SDI De-Embedder DEM 1 … DEM 16].
The signals from the device router [SYSTEM – SDI Embedder EMB 1 … EMB 16] are routed by default
1:1 to the physical embedders [INTERFACE – SDI OUT G1 CH1 … G4 CH4].