KBC Networks FTL1-M1A-B-MSC - Manual (Page 8)

Manual-FTL1-Rev1009.pdf Page 8 of 10 www.kbcnetworks.com
Copyright © KBC Networks Ltd.
Receiver Left View
Connectors:
GND: Grounded pin
DC or AC Power Supply between 12V and 24V can be used on this product.
•
DC:
＋ : +12VDC~+24VDC
－ : Power Supply Ground
•
AC:
There is no difference between ＋/－; the power supply can be connected into the
device directly.
Receiver Right View
Connectors:
TX/RX: Fiber Optic ST
LAN: LAN RJ45
Beside the Ethernet RJ45, there are two LEDs:
The green LED: Ethernet Link. Flashing if the link is in OK
The yellow LED: Fiber Link. Flashing if the link is in OK
2.4 Caution
•
Switch off all power supply before installation.
•
Ensure fiber is properly aligned to the receiving connector. Avoid forcing in the fiber.
•
The FTL1-M1A-MSC/FTL1-M1B-MSC Series is an auto-sensing device.