KBC Networks ESUL8P-PC2 - Manual (Page 7)

Ethernet Switch User Manual
Manual-ESUL8P-PC2_Series_HW-Rev1201
Copyright © KBC Networks Ltd. Page 7 of 15 www.kbcnetworks.com
2.3
Installation Method
2.3.1 DIN Rail Mount
 Remove all packaging material.
 Attach the device to a DIN rail.
 Attach copper cables as required.
 Insert the male power block (attached to the supplied in-line PSU) to the
female power socket on the device and tighten the terminal locking screws
using a flathead screw driver.
See Section 2.7 for LED status.
2.3.2 Wall-mount
 Remove all packaging material.
 Unscrew the DIN rail mounting plate from the switch taking special care to
retain the 3 screws using a Phillips No.1 or No.2 screwdriver.
 Attach the supplied wall mount plates to the switch using the screws that
have just been removed from the DIN rail mounting plate with a Phillips
No.1 or No.2 screwdriver.
 Position the unit on the required, flat surface and secure with screws via the
mounting plate holes. Screws are not provided.
 Attach copper cables as required.
 Insert the male power block (attached to the supplied in-line PSU) to the
female power socket on the device and tighten the terminal locking screws
using a flathead screw driver.
See Section 2.7 for LED status.
2.4 Ethernet RJ45 Connections
Each of the eight fixed RJ45 ports (P1 to P8) are adaptive and support auto MDI/MDI-X
connection. They can be connected by straight through or cross-over cables to terminal
devices, servers, hubs or other switches. Each switch supports IEEE802.3x so the
optimum transmission mode (either half-duplex or full-duplex) and data rate (either
10Mbps or 100Mbps) will be selected automatically.