Installing a sata dom – NEXCOM NISE 3640M User Manual
Page 61
Advertising
Copyright © 2013 NEXCOM International Co., Ltd. All Rights Reserved.
44
NISE 3640M Series User Manual
Chapter 3: System Setup
1. Remove the HDD bracket before installing a SATA DOM.
2. Locate the SATA connector on the board and fasten with the copper post
included in the accessory package.
Installing a SATA DOM
SATA Connector/
SATA Power Connector
Copper Post
3. Connect one side of power cable to the SATA DOM.
Advertising
This manual is related to the following products: