One Systems PM4-M V4 User Manual
Page 6
The required banding and buckle material is based on the specific installation
environment. The term “inland” refers to non-industrial and non-marine/ocean
front environments. The determination of the specific environment is the
responsibility of others.
The required material for “inland” environments is:
BAND-IT # C206R9 stainless steel bands
BAND-IT # C25699 buckles
BAND-IT # C00169 tensioning tool
The stainless steel band is Type 201SS 0.030 inches (0.762mm) thick and 0.750
inches (19mm) wide.
This banding material should be used for “inland”
environments. See below for ocean front and Marine environments.
If the PM4-M
is being installed in an ocean front or Marine environment 316
grade banding material should be used.
BAND-IT # C406R9 stainless steel bands (316 grade)
BAND-IT # C45699 buckles (316 grade)
BAND-IT # C00169 tensioning tool
Figure 4b
ANY QUESTIONS REGARDING THE BANDING SYSTEM SHOULD BE
REFERRED TO BAND-IT TECHNICAL SUPPORT
WARNING: Do NOT substitute banding materials or banding dimensions.