Oxmoor RMX-44 - Manual (Page 15)

Page 13
RMX-44 & RMX-62 SPECIFICATIONS
*SMPTE Method; 60 Hz + 7 kHz mixed 4:1.
** Input terminated w/600 ohms, unity gain, adjacent channel driven to +4 dBm output.
Specifications subject to change without notice.
FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE FREQUENCY RESPONSE 20 Hz to 20 kHz ....................................... +0, -0.3 dB
-3 dB Points, Ref. 1 kHz ............................ 4 Hz to 70 kHz (+4 dBm Output)
HUM AND NOISE HUM AND NOISE HUM AND NOISE HUM AND NOISE HUM AND NOISE Ref. +4 dBm Output @ Unity Gain ............. -85 dB (20 Hz to 20 kHz, Unweighted)
DISTORTION DISTORTION DISTORTION DISTORTION DISTORTION Total Harmonic (THD + NOISE)
Ref. +4 dBm Output @ Unity Gain ............. -80 dB/0.01% (20 Hz to 20 kHz)
Intermodulation (IMD)*
Ref. +4 dBm Output @ Unity Gain ............. -80 dB/0.01%
CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION CROSSTALK & OFF ISOLATION Channel to Channel** .............................. -80 dB (20 Hz to 20 kHz)
Driven Input to Off Output ......................... -80 dB (20 Hz to 20 kHz)
INPUTS INPUTS INPUTS INPUTS INPUTS Type ....................................................... Electronically Balanced (RF Suppressed)
Connectors ............................................. Female XLR
Input Impedance ..................................... 80 k Ohms
Maximum Input Level ............................... +24 dBu
OUTPUTS OUTPUTS OUTPUTS OUTPUTS OUTPUTS Type ....................................................... Electronically Balanced
Connectors ............................................. Male XLR
Source Impedance .................................. 150 Ohms (75 Ohms Each Side)
Recommended Load Impedance .............. 600 Ohms or Greater
Maximum Output Level
(Ref. 1 kHz @ rated THD)
Terminated w/600 Ohms .................... +24 dBm
Unterminated ...................................... +26 dBu
TRIM POT GAIN RANGE TRIM POT GAIN RANGE TRIM POT GAIN RANGE TRIM POT GAIN RANGE TRIM POT GAIN RANGE Ref. 0 dBu Output ....................................
±
15 dB
CONTROL PORT CONTROL PORT CONTROL PORT CONTROL PORT CONTROL PORT Input Type ............................................... Active Low, Internally Pulled Up to +15VDC
Input Protection ....................................... 1/2 Max. Line Voltage, 12 kV Static
Logic Action ............................................. Requires Maintained Closure To Common
Connector ............................................... Female 25 Pin Std. D-Sub
Logic Levels (At Control Port) .................... Low < 3 Volts, High > 7 Volts
Maximum Paralleled Inputs ...................... 64
Maximum Sink Current ............................ 50 mA
Maximum Cable Length ........................... 600m (2000 ft), #22 AWG
Switching Time ........................................ 100 ms
Power Output .......................................... +15 VDC
±
0.1 V, 50 mA
TURN ON DELAY TURN ON DELAY TURN ON DELAY TURN ON DELAY TURN ON DELAY Power Up Delay ....................................... 2 sec
±
0.25 sec
MAINS POWER MAINS POWER MAINS POWER MAINS POWER MAINS POWER Power Requirements ............................... 100 to 125 VAC or 200 to 230 VAC
50/60 Hz; 13 Watts Maximum
Fuse Type ............................................... 125 mA (1/8 amp) SB @ 115 VAC
63 mA (1/16 amp) SB @ 230 VAC
MECHANICAL MECHANICAL MECHANICAL MECHANICAL MECHANICAL Overall Dimensions .................................. 44mm H x 482mm W x 183mm D
(1.72 in. H x 19 in. W x 7.18 in. D)
Finish ...................................................... Textured Black Paint
Weight .................................................... Shipping: 3.8 Kg (8.5 lb.) Net: 3.1 Kg (6.9 lb.)
ACCESSORIES ACCESSORIES ACCESSORIES ACCESSORIES ACCESSORIES Supplied with unit .................................... One DB-25 Male Connector
UL LISTING UL LISTING UL LISTING UL LISTING UL LISTING RMX-44 Mixing Matrix
RMX-44T Mixing Matrix
RMX-62 Mixing Matrix
RMX-62T Mixing Matrix