Premise connectivity systems – Signamax 12- to 48-Fiber Low-Profile Optical Fiber Enclosure User Manual
Page 2
www.signamax.com
16295 N.W. 13
th
Avenue • Miami, FL 33169 • 800.446.2377 • 305.944.7710 • Fax: 305.949.4483
Copyright 2008 Signamax, Inc./AESP, Inc. All rights reserved • Signamax Connectivity Systems is a trademark of AESP, Inc. • Specifications subject to change.
SL2M-B 02052009
Section 3
Cabling the Panel
Bring the bundle of jacketed fiber cables into either
the left or right of the enclosure, through the cable
retainer, and pull the clamp-tab to secure the cable
bundle. Two clamps are in-place, mounted to the
tray, and two additional clamps are supplied for
additional clamping that you might wish to do, when
cabling to the panel-tray. There is a series of through-
holes in the panel-tray for mounting the clamps to the
tray.
figure 4
3.1 Routing the Cables
Route the cables into the box, through either of the oblong slots in either side of the panel frame. Using the
cable clamps shown in Figure 4, be sure cable bundles are properly secured. Use the slack-cable spools in the
center of the tray for storing additional cable lengths. Note that an additional set of screw mounts are included
in the tray-base, to be used if mounting the cable spools further rearward in the tray is desired. After
terminations are made, make the necessary connections to the appropriate connector in the interface module.
If splicing is being used, a splice tray specifically designed for use in the SL2M-B is available. Section 4 deals
specifically with using splice trays.
Section 4
Using Other Cabling Accessories
If splicing is being done in the panel, Signamax offers
a specific splice tray for this panel that can be
ordered, separately. It is Signamax p/n FST-2M-B
(Figure 5). The panel will accommodate up to 2 splice
trays per panel. Each splice tray accommodates up
to 12 splices, and includes a pressure-sensitive pad
for mounting the splices. Splice trays are figure 5
screw-mounted, either individually or in a group of
two trays, with mounting screws provided with each
tray. The splice tray is mounted in line with the cable
management . spool, and can be mounted in both
forward and rear-tray mounting positions. Contact
Signamax at 800-446-2377 for product & accessory
details.
figure 5
Up to 12 splices/tray,
2-trays per panel (24 splices).
Premise Connectivity Systems