Tview T718DVPL-DVD - Manual (Page 6)

5
135~185mm Included Tube Sizes Diameter:
tube diameter: 12mm,12.7mm
14mm, 16mm (1 set for selection)
*Press the tab on the underside of the battery cover and at the same time pull out the
battery tray.
Insert the battery.
Take the CR2025 type battery with stamped(+) mark facing upward. Insert the battery
tray into the remote control.
*Point the remote controller to infrared receiver window of your device within 60
seconds and 3 meters away, without any batteries between them.
*The life-span of the batteries is about one year, always replace the old set with a new
set of batteries.
Please take out the battery when the remote controller is not being operated for a long
time.
*Please pull out the separation film prior to using the remote controller.
WARNING
Store the battery where children can not reach. Do not recharge, disassemble or
heat the battery or dispose of it in a fire.
Installation and wiring
Check to make sure the appearance and specification are a good fit. During the
process, choose the right accessories and tools.
Installation step:
Step1: Remove original pillow
Step2: Choose the correct size tube, in order to fit correctly.
Step3: Connect the power cord and the Video cable
Step4: Set the pillow in place
Battery replacement Instructions for
Remote controller (shown in picture)
HEADREST DVD PLAYER
Pull
Push
(For reference only)
12
(1)While playing the DVD disc, press Repeat for the first time to repeat playing one
chapter, press Repeat for the second time to repeat playing one title, press repeat
for the third time to repeat playing the entire disc, and press Repeat to cancel.
(2)In PBC off mode:
While playing the VCD disc, press Repeat for first time to repeat one song.
Press Repeat for the second time to repeat the entire disc.
Press Repeat for the third time to cancel.
Repeat
Press Mute one or more times to select mute on or mute off.
Mute
While normal playing, press to Pause/Play, press and hold to Stop.
Press this button to select between DVD .
Note: The mode will be remembered when powered off.
Press the Menu button and the screen will show the display for adjusting, Press
Volume to select desired displays: Picture, sound, mode, Press Previous/Next
to select, Press Volume to adjust or Press Up/Down button in remote control to
select, Press Left/Right to adjust desired parameters, Press Menu button to back,
and the parameters will be memorized.
Note:
“Parameters Memorizing” is the setup parameter for last Power Off.
“Setup Reset” is factory parameters, all functions can be reset.
While the unit power off or no signal, the IR transmitter will close automatically
after a while.
Press + - button, it's invalid for adjusting volume of IR/FM, but valid for the player
and earphone.
Note: Volume can be memorized.
and AV
Play/Stop
Mode
Menu
Volume
HEADREST DVD PLAYER