TVLogic LVM-173W-3G - Manual (Page 11)

Multi F
orma
t L
CD M
onit
or
11
Controls, Indicators and Connections
◦ [ASPECT] Button/Lamp
- Used to change the display ratio between 4:3 and 16:9.
- Display ratio locks to 16:9 if the display ratio of input signal is 16:9.
- See section “Other Functions [3] ASPECT Button” for more information.
◦ [MARKER] Button/Lamp
- Used to activate/deactivate the marker.
- The desired aspect ratio can be displayed on the screen properly when the type of marker selected
from the main menu.
- If AFD is selected on the main menu, marker automatically activates when input signal contains
the embedded AFD data.
◦ [H/V DELAY] Button/Lamp
- Used to check horizontal sync and vertical sync simultaneously by moving the display to the left,
right, up and down.
-
In this mode, the brightness of image automatically increase for easy verification of synchronized signals.
◦ [BLUE ONLY/MONO] Button/Lamp
- Used to activate MONO mode or remove red and green from the input signal and display the
screen only under a blue signal.
- In MONO mode, press the button again to activate the Focus Assist mode which will indicate the
edges of the display in the color that is be selected in the Waveform menu.
◦ [CHROMA/PHASE] Button
- Used to activate CHROMA, PHASE and Closed Caption feature when MENU is not activated. Use
UP/DOWN button to control the value.
- Activates in the order below :
SDI-A/B modes : CHROMA -> Closed Caption.
Component mode : CHROMA.
Composite/S-Video modes : CHROMA -> PHASE.
DVI-Analog mode : PHASE (AUTO PHASE).
Selects a PBP screen in PBP mode (Screen 1, Screen 2 or Full Screen).
◦ [W-FORM] Button/Lamp (LVM-173W-3G)
- Used to activate the WAVEFORM/VECTORSCOPE.
- Pressing the button activate features in the order of :
WAVEFORM -> VECTOR -> Y/Cb/Cr -> RGB -> MODE 1 (WAVE FORM/VECTOR) -> MODE 2(VECTOR
/Y/Cb/Cr) -> WIDE-Y (WAVEFORM)
- In PBP mode the feature activates in the order of: WAVEFORM -> VECTOR -> MODE 1 (WAVE FORM/
VECTOR) -> WIDE-Y (WAVEFORM)
* See section “Menu Contents [7] WAVEFORM” for more information.
◦ [MENU] Button
- Used to activate the OSD menu.