WaveWare SPS-5 v9E - Manual (Page 31)

error message and an <RS><CR>, which tells the Host Device to abandon the transaction. An example error message
sequence follows:
514 Checksum Error – Exp. 2:9 Got 2:X<CR><NAK><CR>
PAGING SESSION LOGOUT
The Paging Session Logout mode allows a Host Device, sometimes called a Remote Entry Device, to stop
communications with the paging system. With the WaveWare v9E Paging System, the Logout process is optional. The
WaveWare v
9 Paging System will automatically login a Host Device and process the paging message if it recognizes a
properly formatted TAP message block at any point in its operation.
To initiate a logout (disconnect sequence) the Host Device should send the following to the paging system:
<EOT><CR>
Upon recognizing a logout command, the paging system will respond with:
PAGING EXCHANGE DISCONNECT<CR><ESC><EOT><CR>
This Completes the “Paging Operation”
This Completes the “TAP Interface Specifications”
Com Port and Network Settings: (See Next Page).