WaveWare SPS-5 v9E - Manual (Page 8)

 Frequency - All Paging Receivers used with the WaveWare v9E Paging System must be of the same Frequency
and Must Match the Frequency of the Paging System Transmitter.
See the Label on the back of any WaveWare Transmitter Unit to Identify the Operating Frequency of your Paging
System.
 POCSAG - All Paging Receivers used with the WaveWare v9E Paging System must be
POCSAG Compatible.
POCSAG is the Paging Protocol most frequently used in the paging industry.
 Pager Type - You can mix different paging receiver types in a WaveWare installation. You can obtain the following
paging receiver types for use with the WaveWare Paging System:

Alphanumeric

Numeric

Tone/vibe only, with or without multiple tone/vibrate cadence features.
The WaveWare
SPS-5 v9E Paging System support pagers with multiple tone/vibrate features
Tone/Vibe Pagers have two Cap Codes and have multiple tone/vibrate features.

WaveWare Wireless Message Centers allow group message notification on scrolling multicolor LED
Displays using the WaveWare v9E Paging System to communicate to the message centers.
 Paging Data Rate - You can mix different paging data rates (baud rates) in a WaveWare installation. The data rate
of the paging receivers can be your choice of 512, 1200, or 2400 bps (bits per second).
 Cap Codes - Each paging receiver used in a WaveWare v9E Paging System installation must have one or more
cap codes (addresses) programmed into it. Each paging receiver used with a particular WaveWare v9E Paging
System installation, regardless of paging receiver type, must have a unique cap code programmed into it, in order to
be able to transmit messages to that individual paging receiver. Contact your paging systems dealer for cap code
assignment information.
Message Center used with a PDR WaveWare Wallpager
Alphanumeric Pager Numeric Pager Tone/Vibe Pager
Paging System Operation
Your WaveWare v9E Paging System includes a UHF Transceiver and an onboard Single RS-232 Serial Com Port and
an Ethernet interface for communications, and encodes paging messages for RF transmission using the industry standard
POCSAG paging protocol. The Programmable RS-232 communications allow you to interface the encoder to a PC or to
other devices and systems that use RS-232 serial communications (Host Devices). The programmable Ethernet
communications allows the paging encoder to monitor up to two simultaneous Ethernet connections, with independent
paging control protocols and independent Ethernet port values.
Amplification Kits are also available when more than 5 watts of power is required to obtain better coverage of a site.
The types of paging receivers that are compatible with your WaveWare v9E Paging Encoder include: