WaveWare SPS-5 v9E - Manual (Page 50)

Example 3:
AF0145678C<CR>
Will send a three beep tone/vibe only message at 1200 bps to a tone/vibe only, a numeric, or an
alphanumeric pager with Cap Code 0145678 and multiple tone/vibe cadence capability. Certain paging
receiver models may not be designed to respond to multiple tone/vibe cadence messages.
Example 4:
AS0145678B<CR>
Will send a two beep tone/vibe only message at 2400 bps to a paging receiver with Cap Code 0145678.
RESPONSE TO ALL COMMANDS
The v9E
Paging Systems will respond immediately to Paging Message commands with a status message in one of the
following formats:
Page Queued Okay<CR><LF>
The Page Queued Okay response is sent by the paging encoder to the host system immediately following a command if
the command was understood by the paging encoder. Following are some example error messages output with Scope
protocol.
Error – Invalid Pager ID<CR><LF>
Error – Invalid pager type. Expected A or N<CR><NAK><CR><LF>
Error – Beep code invalid. Expected A,B,C,D<CR><NAK><CR><LF>
<NAK> (Hex code 15) is used to indicate non-acknowledgment of a command from the host system.
This Completes the “Scope Interface Specifications”