Xtramus XG2 V1.3 - Manual (Page 9)

9
XG2 Right Panel LEDs
Type Label LED Description
Amber
Remind user that the SFP+ form factor
transceiver (connector) is connected.
Green
Transceiver (connector) with powered optical
fiber is connected.
Fiber Connector
(Transceiver)
Status
SFP+
OFF No SFP+ transceiver (connector) is plugged.
Green Connector of LR Transceiver is plugged. 10BASE-R
Mode
LR (*Note 1)
Amber Connector of SR Transceiver is plugged.
ON (Green)
Display the Network linked/Active status.
ON at Port A: connection of network cable at
port A is linked.
ON at Port B: connection of optical fiber at
port B is linked.
OFF No connection
Connection
Status
Link/ACT
A B
Blinking Data is receiving.
ON (Green)
Loopback mode of A and B ports is enabled.
Loopback test is the method to send out signal
and quickly back to the same source entity to
test the transmission and route problem of
infrastructure. When loopback is enabled,
XG2 returns incoming data flow back to
original entity.
Loopback Test
Status
(A + B )
OFF Loopback test is disabled.
Blinking Green Status of system operation. System is ready.
System Status SYS
Amber System is starting.
E-mail: [email protected]
Website: www.Xtramus.com
XTRAMUS TECHNOLOGIES ®