Zektor Palladia™ 8X8 - Manual (Page 14)

14 HDA800(V2) User Guide, Version 1.3, 9/12/13
Using the Front Panel
Adjusting the Audio Parameters
Under the Audio menu you can select Levels to adjust: Volume, Bass, Treble, the 5 Band EQ, and Bal-
ance.
Selecting ZTrim allows you to adjust: Minimum Volume, Maximum Volume, and Lip Sync delays for a
zone.
Selecting STrim allows you to adjust: Analog Gain, Digital Gain, and Lip Sync delays for a source.
To adjust audio settings:
Use the SELECT knob to select the “Audio” option.
Then choose between: Levels, ZTrim and STrim depending upon what you wish to update.
In all modes use the ZONE buttons to switch between zones (or sources in the case of STrim).
Use the BACK and NEXT buttons to scroll through the different options:
The Levels options are: Volume, Bass, Treble, EQ1, EQ2, EQ3, EQ4, EQ5, Balance.
The ZTrim options are: Min Volume, Max Volume, Zone Lip Sync.
The STrim options are: Analog Gain, Digital Gain, Src Lip Sync.
Volume Settings
When adjusting the volume of a zone, the range of the volume control is from the Minimum Volume
setting to the Maximum Volume setting. A volume of zero is always fully muted. A volume of 1 is the
value set by the Minimum Volume setting, and a volume of 100 is the value set by the Maximum Vol-
ume setting.
If the volume jumps too much when moving from 0 to 1, then lower the Minimum Volume setting. If
you have to move the volume control too far before hearing anything, raise the Minimum Volume set-
ting. The Maximum Volume setting can be used to limit the volume of the zone to an acceptable value.
There must always be at least a 50dB difference between the minimum volume and the maximum vol-
ume settings. You will be prevented from setting values that are less than 50dB apart.
Gain Settings
You can adjust the gains of the inputs to compensate for sources whose volume is too high, or too low.
The analog and digital inputs can be adjusted separately to allow for the difference in volume between
the analog outputs and the digital outputs of a source.
STrim {Levels} ZTrim
Volume,Tone,EQ,Balance
SELECT
MENU ZONE
SETTING
NEXT BACK