Advanced control, Reference for advanced control commands, Advanced command definitions – Zektor Palladia™ 8X8 User Manual
Page 41: V’ version, Xs’ control settings
HDA800(V2) Serial Protocol, Version 1.3, 9/12/13
41
Advanced Control
Advanced Control
Reference for Advanced Control Commands
These commands are for more advanced control over the HDA800(V2), including front panel light
intensities, changes to serial port behavior, etc.
Advanced Command Definitions
‘V’ Version
Returns the current firmware version of the HDA800(V2).
^V ?$
Response String:
^=V “HDA800-V2”,1.0a,30B2S12345678$
Where:
“HD800-V2”
=
Model
1.0a
= Firmware version
30B2S12345678
= Serial number
‘XS’ Control Settings
Turn on and off operational modes of the HDA800(V2).
The format of the command is:
^XS
settings1,settings2$
Set the control bits to ‘settings1’ and ‘settings2’
^XS +
settings1,+settings2$
Set bits indicated in ‘settings1’ and ‘settings2’ to 1
^XS -
settings1,+settings2$
Reset bits indicated in ‘settings1’ and ‘settings2’ to 0
^XS ?$
Query for current settings
Response String:
^=XS
settings1,settings2$
Where ‘settings1’ is a bitmapped parameter defined as:
ACK - 0=Don’t acknowledge cmds with “^+$”
1=Acknowledge error free commands with a “^+$”
ECO - 0=Do not send a response strings for each cmd. 1=Always send response string when a serial command is issued
CHM- 0=Only send a “.ch” when needed.
1=Always append a “.ch” channel mask to a zone response cmd
CRE - 0=Don’t send CRs/LFs at end of responses
1=End all responses with a carriage return and a line feed.
AUT - 0=Classic Analog/Digital mode.
1=Automatic conversion of Analog/Digital paths.
Value
32768
16384
8192
4069
2048
1024
512
256
128
64
32
16
8
4
2
1
Bit Position
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
Name
0
0
AUT
0
0
0
0
0
0
0
0
CRE
CHM
ECO
ACK
0
Default:
0
0
1
0
0
0
0
0
0
0
0
1
0
1
1
1