Zektor Palladia™ 8X8 - Manual (Page 44)

44 HDA800(V2) Serial Protocol, Version 1.3, 9/12/13
Advanced Control
Response String:
There is no response string to the SS command, this command is write only.
Where ‘settings’ is a bitmapped parameter defined as:
Bit-0 - Save zone input/output mappings, and power state
Bit-1 - Save switch delay times set by the ‘DZ’ command
Bit-2 - *Reserved*
Bit-3 - Save control settings (the ‘XS’ command settings)
Bit-4 - *Reserved*
Bit-5 - Save IP parameters and settings (‘IPA’, ‘IPM’, ‘IPG’, and ‘IPSET’ settings)
Bit-6 - *Reserved*
Bit-7 - *Reserved*
Bit-8 - Save zones’ volume settings
Bit-9 - Save zones’ audio parameters (bass, treble, eq, mute level, zone gains, zone lipsync, etc. all but volume)
Bit-10 - Save source audio parameters (input gains, input lipsync delay)
Bit-11 - Save global audio parameters (master volume, volume and mute fade times)
Bit-15 - Save HDMI settings: EDID and HDCP caches, HDCP key counts, and the EDID lock state.
Note: The HDA800(V2) must be powered on before sending the “Save HDMI settings” (Bit-15).
‘FS’ Reset to Factory Settings
This command will reset selected parameters of the HDA800(V2) to their factory default settings.
This command uses a bitmapped parameter to indicate which values are to be reset. A bit set to ‘1’
indicates the associated setting should be reset, a bit set to ‘0’ indicates the setting should not be reset
and the previous setting will remain unchanged.
Command formats:
^FS settings$ Reset the parameters indicated by ‘settings’
Response String:
There is no response string to the FS command, this command is write only.
Where ‘settings’ is a bitmapped parameter defined as:
Bit-0 - Reset zone input/output mappings, and power state
Bit-1 - Reset switch timings (the ‘DZ’ command settings)
Bit-2 - *Reserved*
Bit-3 - Reset control settings (the ‘XS’ command settings)
Bit-4 - *Reserved*
Bit-5 - Reset IP parameters
Bit-6 - *Reserved*
Bit-7 - *Reserved*
Bit-8 - Reset zones’ volume settings
Bit-9 - Reset zones’ audio parameters (bass, treble, eq, mute level, zone gains, zone lipsync, etc. all but volume)
Bit-10 - Reset source audio parameters (input gains, input lipsync delay)
Bit-11 - Reset global audio parameters (master volume, volume and mute fade times)
Bit-15 - Reset HDMI settings: Clear EDID and HDCP caches, clear HDCP key counts and the EDID lock state.
Value 32768 16384 8192 4069 2048 1024 512 256 128 64 32 16 8 4 2 1
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Value 32768 16384 8192 4069 2048 1024 512 256 128 64 32 16 8 4 2 1
Bit 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0